![]() If they don’t, make a note on theĬard and notify the Referee. For relays, check the name of each swimmer and make sure they swim in that order.If the swimmer misses the touchpad or hits it late, write that (and any other anomaly) on the card or lane timer slip.Out of the pool after the race, help them. Also if your swimmer is having difficulty getting Move the swimmers back and work with the official to share the space. At the end of the race, things get very crowded at the blocks – 2 or 3 timers, an official, and some screaming swimmers.A Runner willĬollect the card or lane timer slips after each heat or event, respectively. If there’s a big discrepancy, report it to the Chief Timer. On the scoreboard – it shouldn’t be the same. If you missed the finish, write “NT” on the card or lane timer slip. Write the time to the hundredth of a second without rounding Once you stop the watch and push the button, step backĪway from the blocks and record the watch time. Every time you push it, the computer records a new time. Push the button only once – that’s all it Get right up to the edge of the pool and lookĭown for the touch … don’t be afraid to get wet. Don’t worry if it’s legal or not – that’s the S&T Judge’s responsibility. Stop your watch and push the button at the end of the race when any part of your swimmer’s body touches any part of the.Scoreboard or lane counter! You need this information to determine when it’s the last lap. If it’sĢ00Y/M or longer, mark them on the card, lane timer slip, or heat sheet, so you don’t loose count. During the race, count the laps of your swimmer. The end of their race, write “DNF” on the card or lane timer sheet. If your swimmer gets out of the pool before If your swimmer misses their heat, write “NS” on the card or lane timer sheet.Always start yourwatch for every heat, even if you don’t have a swimmer in your lane. If your watch fails to start (or stops during the race), raise it over your headĪnd get the attention of the Chief Timer (usually called Head Timer). If you miss the flash, start your watch on the sound of the start signal.įind a spot near your lane where you can see. Not on the sound (do not push the black pad button). The Start Console emits the audio start signal and a simultaneous visual flash. The Referee and Starter are located on the side of the pool along with the StartĬonsole. Once all the swimmers are on the blocks, the Referee will turn the heat over to the Starter.If there’s a problem, get the Referee’s attention immediately. Sometimes it’s confusing and difficult to hear – you must be alert and attentive. When the Referee blows the long whistle (that signals the swimmers to step up onto the blocks), make sure your swimmer #Swimming timer clock series#At the series of short whistles, make sure your swimmer is ready to swim and standing behind the block. Perform this check prior to the Referee’s series of short whistles (that notifies the swimmers and timers it’s time for Swimmer is present to swim by checking the name of the swimmer against the card, lane timer slip, or heat sheet.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |